Installing The Terminal; Getting Ready; Connecting The Terminal - Wyse WY-60 User Manual

GETTING READY
CONNECTING THE TERMINAL
Installing the Terminal
You'll need a shielded serial interface cable (fitted with a male
25-pin connector on the terminal end) to connect the terminal to
your computer or modem. If you plan to connect a serial printer
directly to the terminal, you'll need a second serial cable. (See
Appendix A for connector pin assignments.)
Place the terminal on a flat, hard surface, allowing three inches
on all sides for ventilation.
To connect the terminal, follow these steps:
1 Press the front half of the power switch on the right side of
the terminal to be sure that the terminal is turned off.
2 Plug the keyboard cable into the keyboard socket on the left
side of the terminal.
3 Thread the serial cable(s) through the cable guide at the back
of the terminal base, as shown in Figure 1-1.
4 Connect the computer cable to the MODEM port and the
..
prmter cable to the AUX port.
5 Plug the power cord into the terminal's power connector and
into a three-pronged grounded power outlet.
o
Note Make sure source of electricity is in the range of the
voltage shown on the back of the terminal (115 V in the U. S.
and Canada, 240 V in many other locations).