Programming Automatic Balance For A Vga Optica; Programming Automatic Balance For A 4X40 Optica - GE Optica Operator's Manual

Programming Automatic
Balance for a VGA Optica
Item
Interval
Set how often the automatic balance takes place.
Set the type of balance
Type
(see Sensor Balancing on page 3-10).
Status Set whether the balance will take place.
Set whether the display, analog outputs, and alarms
will track the sensor condition during a cleaning
Track/Hold
cycle, or hold the last process reading.
(Serial outputs always hold the process reading).
Programming Automatic
Balance for a 4x40
Optica
Setting
Interval in Minutes Set how often the balance takes place.
Set the type of balance (see Sensor
Type
Balancing on page 3-10).
Enable Set whether the balance will take place.
Set whether display, analog outputs and
alarms will track the sensor condition
Analog Output
during a cleaning cycle, or hold the last
Tracking
process reading. (Serial output will
always track the process reading.)
Automatic Balance (for earlier software versions)
Note: For Optica Analyzers with software version XXX or later, see
Automatic Cleaning and Balance Function on page 4-9.
Table F-1: Automatic Balance Options
Function
Note: For Optica Analyzers with software version XXX or later, see
Automatic Cleaning and Balance Function on page 5-8.
Table F-2: Automatic Balance Options
Description
Available Options
Enter the interval in minutes
(60 minutes minimum).
Auto, PACER
Enabled, Disabled
Track, Hold
Available Options
Enter the interval in minutes
(60 minutes minimum).
Auto, PACER
Enabled, Disabled
Track, Hold
January 2006
F-1