Wiring to a Personal
Computer
Configuring the Serial Interface
The Optica is configured as Data Terminal Equipment (DTE). The
following pins are used on the Serial interface:
•
2 - Transmitted data (TXD)
•
3 - Received data (RXD)
•
5 - Signal ground (GND)
To send the output of the Optica to a personal computer, use the cable
arrangement shown in Figure C-1 below.
Figure C-1: Wiring Diagram - Optica to Personal Computer
Optica
9-Pin Male
2
3
5
3
2
5
9-Pin
PC
January 2006
C-1