Type SIM-HSL Heated
Sampling Line
Type SIM-MPL Mounting
Plate
Connecting the Sensors
Installation
The SIM-HSL heated sampling line is self-regulated at a temperature
high enough to ensure that no condensation occurs. The line is made
of ¼-inch outside diameter Teflon, with stainless steel fittings.
The SIM-MPL mounting plate is designed to accept one, two or three
heated modules: the heated sensor, the heated filter, and the heated
flow meter. The mounting plate provides a convenient method of
wall-mounting the entire heated sampling system. When ordered with
one or more modules, the factory performs all mounting, plumbing
and wiring work, thus providing a complete system ready for
installation.
Dew point, temperature and pressure sensors provided by GE
Infrastructure Sensing for the Optica monitor are pre-wired with
connectors installed. Plug these connectors into their corresponding
sockets as shown in Figure 2-5 on page 2-5 for the benchtop unit, or
Figure 2-8 on page 2-7 for the wall-mount unit.
January 2006
2-21