Installation Procedures - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 4 Installation

4.1.2 Installation procedures

Table 4-1 Hicom 150 E OfficePro - procedures for system installation
Step
1.
2.
3. Mount the main distribution frame MDFU/MDFU-E
4.
Single cabinet
Two cabinets (side-by-side)
Mount the base elements
(for stacked system cabinets)
5.
6.
7. Lay out the line network and set the jumpers on the MDFU/MDFU-E page 4-23
8. Load the system software (flash memory
9.
10.
11.
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_4m.htm (2 of 27) [06/04/2000 13:04:41]
Installation activity (notes)
Select the installation site
(generally already predefined)
Unpack the components
Set up the system cabinets:
Remove the cabinet cover
Earth the system
Check the protective earth
Connect the cable
Configuration instructions
(board configuration, already completed)
Connect terminals
Perform visual inspection
Two cabinets (stacked)
Three cabinets (stacked)
card)
page 4-3
page 4-3
page 4-4
Starting on
page 4-5
Starting on
page 4-12
page 4-16
page 4-27
page 4-28
page 4-34
page 4-34