Siemens Hicom 150 E Office Service Manual page 312

Hicom 150 E Office Rel.1.0 Service Manual - 7.10 Other features
Relocate Relocate is performed for optiset E terminals only.
Note:
Relocate can only be performed from an optiset E master terminal.
The master terminal and the associated slave (including analog slave extension) are
assigned a new, i.e. the "relocated" telephone number.
All activated features and classes of service are retained by the terminals.
Port 1 and 2 (the administration ports) cannot execute the relocation function.
In Hicom Assistant E, it must be pointed out that the physical ports (called "Access" in the
Assistant) change following relocation. This is important for main distribution frame unit
planning.
A time period of 15 minutes is available for activating the relocate function between
extension A and B.
More than one relocate procedure cannot be activated.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
1. Configure relocate
* 9531994
2. 22-24 => System Options - Relocate proc.
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure relocate
Options
2. System Parameters
3. Flags / CMI
Performing Feature Check
Check the feature for error-free functioning as follows (Example for Hicom 150 E OfficePro):
Step
1. Starting position:
Master ext. 103 has slave ext. with no. 503 (slot 2 / port 4)
Master ext. 104 has slave ext. with no. 504 (slot 2 / port 5)
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_710.htm (18 of 19) [06/04/2000 13:07:31]
Action
Action