Firmware Update; Factory Reset; About Fs-I10 - Fly Sky FS-i10 Instruction Manual

Digital proportional radio control system

10.10 Firmware Update

The internal software of the transmitter can be updated using the USB interface connected via a PC computer.
Once this function is activated, all functions of the transmitter stop. To avoid any loss of control of the vehicle,
turn its receiver off before entering this mode. A confirmation is requested.
When the firmware is updating, never disconnect the USB cable or remove the battery or the transmitter will
become unusable.
This function can be used only when connected with a computer. Follow the steps as shown below:
1. Download and open the newest official software.
2. Connect a transmitter with a computer by USB cable.
Enter [Firmware Update] menu and press [OK] to complete.
3.

10.11 Factory Reset

To reset the system to its factory settings press this option, then select [Yes] to confirm.

10.12 About FS-i10

This option contains basic information about the system such as currents hardware and software versions and
the TX ID.
38
FS-l10