Table of Contents
Advertisement
6. Function Settings
This section contains the default menu function settings.
6.1 Reverse Function
The Reverse function is
used to correct a servo
or motor's direction in
relation to the systems
controls. For example, if a
servo is mounted upside
down in order to fit inside
a model.
To reverse a channel:
This menu contains 10
check boxes, one for
each channel, when a
channel is reversed the
corresponding box will
be checked.
6.2 End Points Function
Endpoints are the limits of the channels' range of
movement. There are two endpoints, one is the low
endpoint and one is the high end point.
Pic.6
To set an endpoint:
1.
Touch the channel you wish to change. The
setup menu for the selected channel displays.
(Pic.5)
Pic.5
(Pic.6)
•
At the top of the current channel, the
selected endpoint and percentage are
shown.
•
The endpoints location is shown as a bar
and needle.
•
The red needle indicates the current setting
for the selected side and channel.
•
A real time readout of the channels position
can be seen in this menu as a green bar.
2.
Select the Up side or Down side as appropriate.
3.
Move the wheel at the bottom of the screen
left to reduce the value or right to increase the
value.
6.3 Subtrim Function
Subtrim changes the center point of the channel. For
example, if the ailerons are slightly out of alignment,
the subtrim could be used to fix this.
To set the subtrim function:
1.
Select the desired channel from the list. The
setup menu for the selected channel displays.
•
At the top of the current channel, the
selected channel and percentage are
shown.
•
The center point location is shown as a
bar and needle.
•
The red needle indicates the current
setting for the selected channel.
•
A real time
readout of
the channels
position can
be seen in this
menu as a
green bar.
2.
Move the wheel
at the bottom of
the screen left to
reduce the value
or right to increase
the value.
(Pic.7)
Pic.7
15
Hide quick links:
Advertisement
Table of Contents
