Helicopter Menu Functions; Throttle Hold; Throttle Mix; Pitch Curve - Fly Sky FS-i10 Instruction Manual

Digital proportional radio control system

8.Helicopter Menu Functions

This chapter introduces helicopter features, in addition to features already described in the chapter 6.
8.1 Throttle Hold（Pic.39）
Throttle hold locks the
throttle to a preset
value, once the throttle
hold function has been
activated the stick will
no long be able to
change the throttle. The
throttle hold function
must be assigned
to a switch or logic
switch to function. The
throttle hold function
can be used as a saftey
function, preventing the
throttle from accidently
being pushed up when
the user is near the
model, or for models
using a gas powered
engine, preventing the
engine from stalling if
the throttle gets too
low.
Setup:
1. Assign to a switch or logic switch
2. Use the wheel to change the throttle hold value.
8.2 Throttle Mix（Pic.40）
This function is
available to helicopters
only. It mixes aileron,
elevator and rudder
control to the throttle
as a slave. For example,
when applying some
elevator, the helicopter
would need slightly
more throttle to
maintain altitude. Using
the mix function, the
helicopter can do this
automatically.
30
Setup:
1. Activate the function by touching the function
on/off icon
Pic.39
screen.
2. Touch the up or down side for either the
aileron, elevator or rudder.
3. Use the wheel to change the value. Repeat as
necessary.
8.3 Pitch
Pitch curve can be used to smooth out or alter the
rotor pitch over the sticks range of movement. For
example if more reaction was needed though a
certain range of the sticks movement then this can
be done by altering pitch curve.
It is possible select various type of curves using the
menu at the bottom left of the screen.
To change the points
on the curve select a
number and move the
wheel, the result will be
displayed on the graph.
.
Setup:
1. Select a curve
Pic.40
2. Touch a point to
3. Use the wheel to
4. Repeat until the
located at the bottom left of the
Curve（Pic.41）
type by touching
the curve menu
icon , select
yes, then a curve
type.
select it.
change its value.
desired curve has
been completed.
FS-l10
Pic.41