Installing Receiver And Servos - Fly Sky FS-i10 Instruction Manual

3.2 Installing Receiver and Servos

Make sure that you find an appropriate location to mouth the receiver in order to, ensure performance,
stability and prevent outside interference.
Installation:
1. Make sure the receiver is mounted away from motors, electonic speed controllers or any device that
emmits excessive electrical noise.
2. Keep the receivers antenna away from conductive materials such as carbon or metal. To ensure normal
function make sure there is a gap of at least 1cm between the antenna and the conductive material.
3. Ensure that the two antennas are mounted at 90 degrees to each other, as shown below.
(26mm)
接收机 Receiver
Note • Do not power on the receiver during the setup process to prevent loss of control.
接收机
Receiver
Switch
Battery
接收机
Receiver
Aux.6
Aux.5
Aux.4
Aux.3
Aux.2
Aux.1
9
Rudder
servo
Throttle
servo
Elevator
servo
Alieron
servo