Governor; Helicopter Structure; Swashplate Type - Fly Sky FS-i10 Instruction Manual

Digital proportional radio control system
8.8 Governor（Pic.46）
The function of a governor is to keep the head speed constant, independent of
varying load on the motor. A constant RPM is a good thing for 3D flight since
the cyclic and rudder functions
the entire flight envelope. Depending on the size of the helicopter the governors
responsiveness needs to be adjusted in order to stop the helicopter from
oscillating (The tail moving from side to side)
The governor channel is channel 9.
Setup:
1. Use the wheel to change the value.
2. Test and adjust as necessary until you have the desired result.
This function can be set with up to 5 conditions.
8.9 Helicopter Structure（Pic.47）
Helicopter structure enables you to set the control surfaces on your model. Touch each control surface
available on your model so that a tick is displayed in a box next to the name.
Surface
Variable pitch
Throttle Needle
Gyroscope

Governor

8.10 Swashplate Type（Pic.48）
The system supports 7 different types of swash plate, consult your models user manual to determine which
type of swash plate you have.
Setup:
Touch the relevant swashplate type for your model. The currently selected swashplate type will be
highlighted in yellow.
32
(and gyro gain) will remain constant throughout
or being too sluggish.
Function
Pitch Curve, Swashplate Mix, Swashplate ring
Throttle Curve
Gyroscope
Governor
Pic.47
Pic.48
FS-l10
Pic.46