Table of Contents
Advertisement
8.4 Swashplate
Mix（Pic.42）
This function is used to edit the pre-programmed
mix control of the helicopter's aileron, elevator and
pitch.
Adjust the motion range
of these three functions
to achieve the desired
maneuverability. Refer
to your models manual
to ensure best results.
Setup:
1. Select aileron,
elevator or pitch..
2. Move the wheel to
modify the value.
3. Repeat as needed.
This function can be
set with up to 5
conditions.
8.5 Swashplate
Ring（Pic.43）
This function is to limit
swash plates range
of movement achieve
different control
difficulties. For example
a beginner might use
a smaller swashplate
ring setting in order to
prevent any extreme
movement caused by
mistakes when flying.
The swashplate ring
will be displayed on
the graph with a real
time display of stick
movement. When stick
movement moves
beyond the swashplate
ring setting, an X will be
displayed showing the
swashplate limited
position, however the system will still display the
sticks real position, shown as a line leading to a box.
Setup:
1. Activate the function by touched the function
on/off icon
located at the bottom left of
the screen.
2. Move the wheel to change the value.
8.6 Hover
If your model is moving up or down, or moving in a
direction when hovering, use this function to correct
this. If the model is gaining or losing altitude, adjust
the throttle setting. If the model is drifting back or
Pic.42
forward then adjust the pitch setting.
Setup:
1. Assign both throttle control and pitch control in
2. Select pitch or
3. Use the wheel to
4. Test and repeat until
Take weather
This function can be
Pic.43
8.7 Gyroscope
This function is used for adjusting the gyro sensitivity.
If the sensitivity is too high the helicopter will oscillate
(Tail moving from side to side)
too low the helicopter
will be sluggish and
unresponsive. The
default channel is
channel 5.
Setup:
1. Move the wheel
2. If required this
3. Test and repeat
Adjust（Pic.44）
the switch assignment menu [icon].
throttle by
touching its box
located in the rate
column.
change the value.
the model can
hover predictably.
conditions, wind
and drafts into
account.
set with up to 5
conditions.
（Pic.45）
to change the
value.
function can be
assigned to a
switch or logic
switch
.
until you have
the desired
result.
This function can
be set with up to
Pic.44
and if the sensitivity is
Pic.45
31
Hide quick links:
Advertisement
Table of Contents
