Timers - Fly Sky FS-i10 Instruction Manual

These functions are also known as basic functions, as referred to in the [Trainer Mode], [Curve Mixes],
[Function Delay] and [Linear mixes] sections of this user manual.
Some functions can apply the function of one control surface to another, for example, the aileron function can
apply aileron control to flaps and elevators. This can be used to enhance the effect of a control surface in order
to make the model more responsive and agile. To see what control surfaces are required for these functions
refer to the table below.
Basic Functions
Aileron function
Elevator function
Throttle Curve
Rudder Function
Flap Function
Spoiler Function
Throttle Needle
Pitch Curve
Gyroscope Function
Governor Function
6.21

Timers

(Pic.25)
This function is usually used to keep track of time to reduce the risk of aircraft running out of battery/fuel and
crashing. These are very useful when used in conjunction with a toggle.
Model/Engine Timer:
The engine timer triggers when throttle value exceeds the set value, and stops when back under that value.
Setup:
1. Activate the function by pressing the function on/off icon
2. To change the timer trigger percentage just move the wheel.
• Both timers can be reset by touching [Reset] button.
Multi-purpose timer:
Up timer: starts counting from zero when triggered.
Down timer: counts down from a selected time, to
select the time you wish to count down from select
min/sec/ms and use the wheel to select the time.
Down then up timer: start from a selected time and
count down, once they reach 0 they go into the
negative and effectively start counting up again.
Setup:
1. Select a timer type.
2. Select start to start the timer and reset to reset.
Airplane Structure
2 Ailerons 2 Flaps,2 Elevators
2 Ailerons, 2 Elevators
Engine
Rudder
2 Flaps, 2 Ailerons
2 Spoilers
Throttle Needle
Variable pitch
Gyroscope
Governor
.
Pic.25
23