Table of Contents
Advertisement
Digital proportional radio control system
2.2.6 Stick Mode
The system supports 4 stick modes, the default is [Mode 2]. The blue icon indicates the currently selected
mode. Enter the main menu, touch the [System] icon and select your prefered mode.
Mode
Elevator
Mode
Elevator
Changing from modes 2/4 to 1/3 will change the throttle position. This
will require the user to open the system and switch the stick positions. The
gimbals can be switched by following these instructions.
Instructions：
1.
Open the battery compartment and remove the battery.
2.
Remove the grips located on each side of the transmitter.
3.
Use a hex screwdriver to remove the 6 screws securing the back cover.
4.
Gently open the transmitter cover and remove the connectors attaching the front to the back from the
botherboard.
5.
Use a philips screwdriver to remove the 8 screws at each corner of the gimbals.
6.
Switch the left and right gimbal, rotate 180 degrees, adjust the wire and secure using the 8 screws.
7.
Carefully insert the connectors back into the motherboard, reclose the transmitter and secure with the
back covers screws.
8.
Reattach the grips and install the battery.
9.
Turn on the transmitter, enter the main menu and open the [Display servos] function. Check the channels
and trims are responding as expected.
6
Throttle
Throttle
Throttle
Throttle
Mode
Elevator
Mode
Elevator
FS-l10
Hide quick links:
Advertisement
Table of Contents
