Manual Selector Assembly - Suzuki GRAND VITARA XL-7 Owner's Manual

7B1-46 AUTOMATIC TRANSMISSION (4 A/T)

MANUAL SELECTOR ASSEMBLY

1. Manual lever assembly
2. Select indicator assembly
3. Illumination assembly
4. Bulb filter
5. Bulb
6. knob assembly
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Remove console box.
3) Disconnect connector for illumination lamp, shift lock sole-
noid (if equipped) and overdrive OFF switch (if equipped).
4) Remove selector assembly mounting bolts.
5) Disconnect selector cable (1) from manual selector assem-
bly (2) expanding selector cable clip (3).
INSTALLATION
Reverse removal procedure to install manual selector assembly
noting the following instructions.
• Make sure that selector cable clip (3) hold selector cable (1)
on manual selector assembly (2) securely.
• Tighten manual selector assembly mounting bolts as speci-
fied torque.
Tightening Torque
Manual selector assembly mounting bolts :
18 N·m (1.8 kg-m, 13.5 lb-ft)
• Connect interlock cable end to cam referring to step 2) to 8)
of "Interlock cable installation" of the service manual men-
tioned in FOREWORD of this manual, if necessary.
• Confirm that brake (key) interlock system operates properly
(if equipped).
7. Shift lock solenoid (if equipped)
8. Manual selector assembly mounting bolt
Tightening torque