Idle Speed/Idle Air Control (Iac) Duty Inspection; [Using Suzuki Scan Tool] - Suzuki GRAND VITARA XL-7 Owner's Manual

ENGINE AND EMISSION CONTROL SYSTEM (SEQUENTIAL MULTIPORT FUEL INJECTION FOR H27 ENGINE) 6E2-15
Idle Speed/Idle Air Control (IAC) Duty Inspec-
tion
Before idle speed/IAC duty check, make sure of the following.
• Lead wires and hoses of engine/emission control systems
are connected securely.
• Accelerator cable is adjusted.
• Ignition timing is within specification.
• All accessories (wipers, heater, lights, A/C, etc.) are out of
service.
• Air cleaner has been properly installed and is in good condi-
tion.
• ECM (PCM) does not detect any malfunction DTC.
After above items are all confirmed, check idle speed and IAC
duty as follows.
NOTE:
Before starting engine, place transmission gear shift
lever in "Neutral" (shift selector lever to "P" range for A/T
vehicle), and set parking brake and block drive wheels.

[Using SUZUKI scan tool]

1) Connect SUZUKI scan tool to DLC with ignition switch OFF.
Special tool
(A) : SUZUKI scan tool
2) Warm up engine to normal operating temperature.
3) Check IAC duty and idle speed by using "Data List" mode of
SUZUKI scan tool.
Engine idle speed:
A/C OFF: 700 ± 50 r/min.
A/C ON: 750 ± 50 r/min.
IAC duty at specified idle speed:
5 – 40 % (at A/C OFF)
4) If duty and/or idle speed is out of specifications, check idle
air control system referring to "DIAG. FLOW TABLE B-4" in
Section 6-1.
5) Check that specified engine idle speed is obtained with A/C
ON if vehicle is equipped with A/C. If not, check A/C ON sig-
nal circuit and idle air control system.