Handling And Storage - Suzuki GRAND VITARA XL-7 Owner's Manual

3) Connect Yellow connector (1) of passenger air bag (inflator)
module, and be sure to lock connector with lock lever.
a) Connect connector.
b) Lock connector with lock lever.
4) Install glove box.
5) Install "AIR BAG" fuse to "AIR BAG" fuse box.
6) Turn ignition switch to ON and verify that "AIR BAG" warning
lamp flashes 6 times and then turns off.
If it does not operate as described, perform "AIR BAG DIAG-
NOSTIC SYSTEM CHECK" in this section.

Handling and storage

SDM
WARNING:
Never power up air bag system when SDM is not rigidly
attached to the vehicle. Otherwise, personal injury may
result.
CAUTION:
After detecting one time of such collision as to meet
deployment conditions, the SDM must not be used. Refer
to "AIR BAG DIAGNOSTIC SYSTEM CHECK" when
checking the SDM.
• Never attempt disassembly of SDM.
• When storing SDM, select a place where neither high tem-
perature nor high humidity is anticipated and oil, water and
dust are kept off.
• If SDM has been dropped, replace it with a new one.
• If installation part of SDM was damaged, repair that part
completely before reinstallation.
• All SDM and mounting bracket fasteners must be carefully
torqued and the arrow must be pointed toward the front of
the vehicle to ensure proper operation of the air bag system.
AIR BAG SYSTEM 10B-51