Rear Axle Shaft Inner Oil Seal; Rear Axle Housing - Suzuki GRAND VITARA XL-7 Owner's Manual

Rear Axle Shaft Inner Oil Seal

INSTALLATION
1) Using special tool drive in oil seal until it contacts oil seal pro-
tector in axle housing.
NOTE:
• Make sure that oil seal is free from inclination as it is
installed.
• Refer to the figure so that oil seal is installed in proper
direction.
Special tool
(A) : 09924-74510
(B) : 09944-88210
"A" : Grease 99000-25010
"B" : Sealant 99000-31110
1. Hammer
2. Rod
3. Oil seal protector
2) For procedure hereafter, refer to steps 6) to 11) of "INSTAL-
LATION" under "REAR AXLE SHAFT" in the service manual
mentioned in the FOREWORD of this manual.

Rear Axle Housing

INSTALLATION
For Step 1) to 4), 7) and 9) to 30), refer to the same section in the
Service Manual mentioned in the FOREWORD of this manual.
3) Clean mating surfaces of axle housing (1) and differential
carrier and apply sealant "A" to housing side.
"A" : Sealant 99000-31110
4) Install differential carrier assembly to axle housing and
tighten carrier bolts to specified torque.
Tightening torque
Differential carrier bolt (a) :
55 N·m (5.5 kg-m, 40.0 lb-ft)
REAR SUSPENSION 3E-5
4. Oil seal
5. Body center