Generator Assembly
1. Pulley nut
2. Pulley
3. Drive end bearing
4. Stator
5. Stud bolt
Unit Repair Overhaul
6. Driver end bearing
11. Wave washer
7. Bearing retainer
12. Rear end frame
8. Rotor
13. Seal plate
9. End housing bearing
14. Rectifier
10. Bearing cover
15. Insulator
Inspection
Rotor
16. Regulator
17. Brush
18. Brush holder
19. Brush holder cover
20. Rear end cover
• Using ohmmeter, check for continuity between slip rings of
rotor. If there is no continuity, replace rotor.
Standard resistance between slip rings of rotor
: 1.6 – 2.0 Ω Ω Ω Ω at 20°C (68°F)
CHARGING SYSTEM 6H-3
21. Terminal plate