Instrumentation; Start/Stop Panel; Power Trim Control Panel - Volvo 5.0OSiE-J Operator's Manual

Appendix

Instrumentation

This section describes the Volvo Penta instrumentation and their functions.
NOTICE! If you want to supplement the instrumentation, your boat is equipped with instruments not described
here, or you are not sure about their functionality, please contact your Volvo Penta dealer or boat dealer.
126
51272
51273
16783

Start/Stop Panel

The start/stop panel is situated on stations other than
the main station.
A. Panel for single engine installations
B. Panel for twin engine installations
NOTICE! Please refer to the chapter entitled Opera-
tion, starting on page 33, before attempting
to start the engines.
The ignition key(s) on the main station must be in the
ON or RUN position I to be able to start the engines
with the start buttons on the start/stop panel. The en-
gines can only be started and stopped if no other sta-
tion is locked. Always push the buttons firmly for at
least one second.

Power Trim Control Panel

The power trim control panel can be used for both sin-
gle and twin engine installations.
For twin engine installations, the power trim control
panel can be used to make individual or simultaneous
adjustments to the drives. The position of the drive
is shown on a trim instrument or a display.
For more detailed information please refer to Power
Trim on page 143 and Power Trim and Tilt Operation
on page 37.
EC
EVC User's Guide
VPA 7748131 English 09-2007