Monitor Output Features; Monitor-Out Level; Solo-Off - Crest Audio X-Four Owner's Manual

monitor output features

The output section controls the audio feed for the console oper-
MONITOR
ator. Features are similar to those of
section is normally used to access the
ITOR
outputs.
Like the alternate output section, it provides the ability to assign the left
and right signals to a designated pair of balanced male XLR con-
MASTER
nectors on the rear-panel.
By utilizing the mode switches located below the
level control, these signals can be derived in a number of different ways. In
default mode (no switches depressed), the post-fader left and right
signals are routed through
balanced male XLR connectors on the rear-panel.
MONITOR OUT
This feed is replaced by the
console.

monitor-out level

see—alternate out
sum mono
see—alternate out

solo-off

When any of the
/ audio is routed in stereo through the
AFL PFL
and appears at the left and right
nector on the rear-panel.
This setting overrides the left and right feed to the
When any of the
outputs are not affected.
MONITOR
headphone level
This control governs the level at the headphone jack located in the
front of the console under the arm rest.
section,except that the
ALT OUT
SOLO
LOCAL MONITOR OUTPUT
level control and appear at the
LOCAL MONITOR
signal when a
SOLO SOLO
/ switches on the console are active, the
AFL PFL
MONITOR OUT
balanced male XLR con-
MONITOR OUT
/ switches on the console are active, the
AFL PFL
-
MON
system as well as main
MASTER
is activated on the
level control
output.
MONITOR
master module
5
p. 67