Controlling Atm Alarm Reporting - Cisco 10000 Series Configuration Manual

Chapter 1 4-Port OC-3/STM-1 ATM Line Card Configuration
Where:
•
•
The default s1s0 value is 0.
The following example shows how to assign a value of 2 to the ATM flag:
Router(config)# interface atm 5/0/0
Router(config-if)# atm flag s1s0 2

Controlling ATM Alarm Reporting

To control selected SONET alarms so that they are logged to the console for an ATM interface, use the
atm report interface configuration command.
atm report {b1-tca | b2-tca | b3-tca | lais | lcd | lrdi | pais | plop | prdi | rdool |
sd-ber | sf-ber | slof | slos}
no atm report {b1-tca | b2-tca | b3-tca | lais | lcd | lrdi | pais | plop | prdi | rdool |
sd-ber | sf-ber | slof | slos}
Where:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
To disable logging of select SONET alarms, use the no form of this command.
Reporting an alarm means that the alarm can be logged to the console. Not all alarms are logged. SONET
alarm hierarchy rules dictate that only the most severe alarm of an alarm group is reported. Whether an
alarm is reported or not, you can view the current state of a defect by checking the Active Defects line
from the show controllers atm command output.
The following example shows how to enable reporting of SD-BER and LAIS alarms on the interface:
Router(config)# interface atm 3/0/0
Router(config-if)# atm report sd-ber
Router(config-if)# atm report lais
Router(config-if)# end
Router#
OL-8834-04
s1s0 is part of the payload pointer byte
value is from 0 to 3
b1-tca—B1 bit error rate (BER) threshold crossing alarm
b2-tca—B2 BER threshold crossing alarm
b3-tca—B3 BER threshold crossing alarm
lais—Line Alarm Indication Signal
lcd—Loss of cell delineation
lrdi—Line Remote Defect Indication
pais—Path Alarm Indication Signal
plop—Path Loss of Pointer
prdi—Path Remote Defect Indication
rdool—Receive Data Out Of Lock
sd-ber—Line bit interleave parity error (LBIP) BER in excess of signal degrade (SD) threshold
sf-ber—LBIP BER in excess of signal fail (SF) threshold
slof—Section Loss of Frame
slos—Section Loss of Signal
Cisco 10000 Series Router Line Card Configuaration Guide
ATM Commands
1-13