Designating An Sts-1 Path As A T3 Or Vt Under Sonet Framing - Cisco 10000 Series Configuration Manual

Creating a T3, VT, or AUG Controller
•
•
•
•

Designating an STS-1 Path as a T3 or VT under SONET Framing

When the 1-Port Channelized OC-12/STM-4 line card is configured for SONET framing, you can use
the path command to designate an STS-1 path as a T3 or VT controller. You can designate up to 12
STS-1 channels.
interfaces, and T1 interfaces.
path STS_number controller {t3 | vt}
Where STS_number is the virtual T3 or VT controller. Enter a value from 1 to 12.
Use the no form of the command to remove a T3 controller.
In the following example, STS-1 number 1 is defined as a T3 line and controller T3 number 2/0/0.1 is
generated:
Router(config)# controller sonet 2/0/0
Router(config-controller)# path 1 controller t3
In the next example, STS-1 number 1 is defined as a VT line and a VT controller 2/0/0.1 is generated:
Router(config)# controller sonet 2/0/0
Router(config-controller)# path 1 controller vt
Designating an STM-4 Port as an AU-3 or AU-4-TUG-3 Controller under SDH
Framing
When the 1-Port Channelized OC-12/STM-4 line card is configured for SDH framing, you can use the
aug controller command to specify the mode of operation for an STM-4 port as an AU-3 controller or
an AU-4-TUG-3 controller. This command creates 12 subcontrollers of the designated type, which you
can then configure like any other controller.
[no] aug controller <au-3|au-4-tug-3>
Where au-3 and au-4-tug-3 designate the type of controller. Enter a value from 1 to 12.
Use the no form of the command to remove an AU-3 or AU-4-TUG-3 controller.
The format of the name for these controllers requires you to add a subport extension to the SONET
controller name. The subport extension is different for AU-3 and AU-4-TUG-3 controllers.
AU-3 Controller
For an AU-3 controller, the syntax is:
controller au-3 <slot>/<subslot>/<port>.<AU-3#>
For example, the following command Uses AU-3 controller #3 on port 0 of a line card in slot 2.
Router(config-controller)# controller au-3 2/0/0.3
Cisco 10000 Series Router Line Card Configuaration Guide
6-16
Unchannelized T3 Commands under SONET or SDH Framing, page 6-17
Channelized T3 Commands under SONET or SDH Framing, page 6-21
Creating T1 or E1 Channel Groups under SONET or SDH Framing, page 6-26
Channelized T1 Commands under SONET or SDH Framing, page 6-29
(Figure 6-1 on page 6-22
Chapter 6 1-Port Channelized OC-12/STM-4 Line Card Configuration
shows the relationship between the OC-12, T3 interfaces, VT
OL-8834-04