Specifying The Idle Pattern - Cisco 10000 Series Configuration Manual

Chapter 4 4-Port Channelized T3 Half-Height Line Card Configuration
•
•
•
•
•
•
The default is that no MDL message is configured.
Use the no form of the command to remove an MDL message.
Examples of configuring MDL messages follow:
•
•
•
•
•
•
•
•
•
•

Specifying the Idle Pattern

You can set a specific pattern to be transmitted between HDLC packets on all unconfigured time slots
that belong to a channelized T3 interface. To do so, use the idle pattern command.
[no] idle pattern patterns
OL-8834-04
lic is the location identification code (up to 11 characters).
fic is the frame identification code (up to 10 characters).
unit is the unit identification code (up to 6 characters).
pfi is the facility identification code to include in the MDL path message
(up to 38 characters).
port is the equipment port (which initiates the idle signal) to include in the MDL idle signal message
(up to 38 characters).
generator is the generator number to include in the MDL test signal message (up to 38 characters).
Enable the MDL path message transmission.
Router(config)# controller T3 1/0/0
Router(config-controller)# mdl transmit path
Enable the MDL idle signal message transmission.
Router(config-controller)# mdl transmit idle-signal
Enable the MDL test signal message transmission.
Router(config-controller)# mdl transmit test-signal
Enter the equipment identification code.
Router(config-controller)# mdl string eic router A
Enter the location identification code.
Router(config-controller)# mdl string lic test network
Enter the frame identification code.
Router(config-controller)# mdl string fic building b
Enter the unit identification code.
Router(config-controller)# mdl string unit abc
Enter the facility identification code.
Router(config-controller)# mdl string pfi string
Enter the port number to send in the MDL idle signal message.
Router(config-controller)# mdl string port string
Enter the generator number to send in the MDL test signal message.
Router(config-controller)# mdl string generator string
Cisco 10000 Series Router Line Card Configuaration Guide
Channelized T3 Commands
4-15