8-Port Fast Ethernet Half-Height Line Card
Configuration
This chapter describes procedures for configuring the Cisco 10000 series 8-Port Fast Ethernet
Half-Height line card, hereafter known as the 8-Port Fast Ethernet Half-Height line card.
The 8-Port Fast Ethernet Half-Height line card contains eight 100BASE-TX ports. Each port
autonegotiates between half and full duplex mode. Each port supports 100BASE-T, but does not support
10BASE-T.
This chapter contains the following sections:
•
•
•
•
For information about installing half-height line cards in subslot locations, see the
Note
Router Line Card Hardware Installation
Software Support
Table 9-1
Ethernet Half-Height line card.
Table 9-1
Required PRE
PRE1
PRE2
OL-8834-04
Software Support, page 9-1
Default Values, page 9-2
Management Port, page 9-2
Configuring the Interface, page 9-3
shows the minimum Cisco IOS release on each release train that supports the 8-Port Fast
8-Port Fast Ethernet Half-Height Line Card Software Support
Minimum Cisco IOS Releases
Cisco IOS Release 12.0(23)S and later releases of Cisco IOS 12.0S
Cisco IOS Release 12.2(15)BX and later releases of Cisco IOS 12.2BX
Cisco IOS Release 12.3(7)XI and later releases of Cisco IOS 12.3 XI
Cisco IOS Release 12.2(28)SB and later releases of Cisco IOS 12.2SB
C H A P T E R
Guide.
Cisco 10000 Series Router Line Card Configuaration Guide
9
Cisco 10000 Series
9-1