Cisco 10000 Series Configuration Manual page 192

Interface Syntax
Interface Syntax
To specify an unchannelized or channelized interface on the 4-port STM-1 line card in a configuration
command, use the syntax shown in
Table 7-12
Type of Interface
Unchannelized
Channelized
Examples:
•
•
SONET-Framed Interface Configuration Sample
You can configure up to 12 STS-1 connections on a 4-Port Channelized OC-3/STM-1 line card. Each
STS-1 connection can be configured as a T3 controller or as a VT controller.
The following procedure walks you through the basic steps for creating full-rate and subrate T3
interfaces, as well as T1 and fractional T1 interfaces. Each T3 controller can be configured as a single
T3 interface (full or subrate), as 28 T1 interfaces, or as an even larger number of fractional T1s.
Set the framing type to SONET using the framing command.
Step 1
Router(config)# controller sonet 2/0/0
Router(config-controller)# framing sonet
Assign an STS-1 path to a T3 interface. In this example, the path command is used to set up four T3
Step 2
interfaces:
Router(config-controller)# path 1 controller t3
Router(config-controller)# path 2 controller t3
Router(config-controller)# path 3 controller t3
Router(config-controller)# exit
Create an interface. In the following examples, each type of interface is created in a different T3
Step 3
controller (4/0/0.1 through 4/0/0.4).
Full-Rate T3 Interface
a.
Cisco 10000 Series Router Line Card Configuaration Guide
7-8
Interface Syntax for the 4-Port Channelized OC-3/STM-1 Line Card
Slot Sub-slot Port
1 to 8/ 0/
1 to 8/ 0/
Modifying T1 interface 6 in controller configuration mode:
Router(config)# controller t3 2/0/0.1
Router(config-controller)# t1 6 command
Modifying T1 interface 6, channel group number 8 in interface configuration mode:
Router(config)# interface serial 2/0/0.1/6:8
Router(config-if)
Enter controller configuration mode.
Router(config)# controller t3 2/0/0.1
Router(config-controller)#
Chapter 7 4-Port Channelized OC-3/STM-1 Line Card Configuration
Table 7-12.
STS-1 Path (T3)
0 to 3. 1 to 12
0 to 3. 1 to 12/
T1 or E1 Channel Group
Number Number
— —
1 to 28: for T1 0 to 23 for T1
1 to 32: for E1 0 to 31 for E1
OL-8834-04