Configuring Alarm Reporting; Configuring Clock; Configuring Sts-1 Modes - Cisco ASR 900 Series Configuration Manual

Configuring SONET
Use the no shutdown command to disable the interface.
Note

Configuring Alarm Reporting

To configure alarm reporting, use the following commands:
enable
configure terminal
controller sonet 0/0/16
alarm-report b2-tcs
end
To restore the system to its default condition, use the no form of the command.
Note

Configuring Clock

To configure clock, use the following commands:
enable
configure terminal
controller MediaType 0/0/16
mode sonet
controller sonet 0/0/16
clock source line
end
Note The default mode is internal.
To restore the system to its default condition, use the no form of the command.
Note
Configuring Network-Clock SONET
To configure network-clock SONET, use the following commands:
enable
configure terminal
network-clock input-source 1 controller sonet 0/0/16
end

Configuring STS-1 Modes

To configure STS-1 modes, use the following commands:
enable
configure terminal
controller sonet 0/0/16
sts-1 1
mode vt-15
end
1 port OC48/ 4 port OC12/OC3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco IOS
Managing and Monitoring SONET Line
XE Fuji 16.7.x (Cisco ASR 900 Series)
77