Software Support - Cisco 10000 Series Configuration Manual

4-Port OC-3/STM-1 ATM Line Card Configuration
This chapter describes the procedures for configuring the Cisco 10000 series 4-Port OC-3/STM-1c ATM
line card, hereafter known as the 4-Port OC-3/STM-1 ATM line card.
The 4-Port OC-3/STM-1 ATM line card is a NEBS-compliant device that performs Layer 2
Asynchronous Transfer Mode (ATM) functions. This line card receives and transmits ATM cells on each
network physical interface connected to a line card port, and simultaneously transmits and receives
packets from the Cisco 10000 series router backplane.
This chapter contains the following sections:
•
•
•
•
•
•

Software Support

Table 1-1
OC-3/STM-1 ATM line card.
Table 1-1
Required PRE
PRE1
PRE2
OL-8834-04
Software Support, page 1-1
Default Values, page 1-2
Line Card VC Limitations, page 1-2
Interface Syntax, page 1-3
Interface Configuration Examples, page 1-4
ATM Commands, page 1-6
shows the minimum Cisco IOS release on each release train that supports the 4-Port
4-Port OC-3/STM-1 ATM Line Card Software Support
Minimum Cisco IOS Releases
Cisco IOS Release 12.0(21)SX and later releases of Cisco IOS Release 12.0SX
Cisco IOS Release 12.0(20)ST and later releases of Cisco IOS Release 12.0ST
Cisco IOS Release 12.0(22)S and later releases of Cisco IOS Release 12.0S
Cisco IOS Release 12.2(8)BZ and later releases of Cisco IOS Release 12.2BZ
Cisco IOS Release 12.3(7)XI and later releases of Cisco IOS 12.3XI
Cisco IOS Release 12.2(15)BX and later releases of Cisco IOS Release 12.2BX
Cisco IOS Release 12.2(28)SB and later releases of Cisco IOS 12.2SB
C H A P T E R
Cisco 10000 Series Router Line Card Configuaration Guide
1
1-1