Cisco 10000 Series Configuration Manual page 10

Contents
4-Port Channelized OC-3/STM-1 Line Card Configuration
7
C H A P T E R
Cisco 10000 Series Router Line Card Configuration Guide
x
Configuring a T3 Interface as Channelized
Setting the Framing Type
Entering MDL Messages
Specifying the Idle Pattern
Setting the T3 Clock Source
Configuring the Loopback Mode for a T3 Controller
Configuring a T3 Controller to Respond to Remote Loopback Commands
Creating T1 or E1 Channel Groups under SONET or SDH Framing
Creating Channel Groups for T1 SONET-Framed Interfaces
Creating Channel-Groups for SDH-Framed Interfaces
Channelized T1 Commands under SONET or SDH Framing
Setting the Framing Format
Controlling Yellow Alarms
Setting the T1 Clock Source
Configuring FDL
Configuring a T1 BER Test
Configuring Loopback Mode
Software Support
7-2
Checking Hardware and Software Compatibility
SONET Channelization
7-2
SDH Channelization
7-3
Default Values
7-4
Default Values for SONET Framing
Default Values for SDH Framing
Interface Syntax
7-8
SONET-Framed Interface Configuration Sample
SDH-Framed Interface Configuration Sample
Show Controller Command Syntax
AU-3 Controller Interfaces
AU-4-TUG-3 Controller Interfaces
Configuring the SONET Controller for SONET or SDH Framing
Entering Controller-Configuration Mode
Selecting SONET or SDH Framing
Configuring the SONET Controller Loopback Mode
Creating a T3, VT, or AUG Controller
Designating an STS-1 Path as a T3 or VT under SONET Framing
Designating an STM-4 Port as an AU-3 or AU-4-TUG-3 Controller under SDH Framing
6-22
6-22
6-23
6-24
6-24
6-29
6-30
6-30
6-30
6-31
6-31
7-2
7-4
7-6
7-8
7-10
7-11
7-12
7-13
7-14
7-14
7-15
6-25
6-25
6-26
6-26
6-27
6-29
7-1
7-14
7-15
7-15
7-16
OL-8834-04