Saving The Configuration; Viewing The Configuration - Cisco 10000 Series Configuration Manual

Chapter 9 8-Port Fast Ethernet Half-Height Line Card Configuration

Saving the Configuration

After completing your configuration changes, save the configuration by following these steps:
To exit configuration mode, either enter Ctrl-Z or enter the following command:
Step 1
Router(config-if)# end
Write the new configuration to memory by entering:
Step 2
Router# copy running-config startup-config
When the configuration is stored, an OK message appears.

Viewing the Configuration

You can check the configuration using the following command:
Router# show interface FastEthernet slot/subslot/port
Disabling the Interface
The interface is enabled by default. To disable it, enter:
Router(config-if)# shutdown
To enable the interface, enter:
Router(config-if)# no shutdown
OL-8834-04
Cisco 10000 Series Router Line Card Configuaration Guide
Configuring the Interface
9-5