Configuring Full-Rate Channelized E1 Bandwidths - Cisco 10000 Series Configuration Manual

Configuration Task Overview
Write the new configuration to NVRAM:
Step 11
Router# copy running-config startup-config
Router#

Configuring Full-Rate Channelized E1 Bandwidths

The following example shows you the steps you use to create a channelized full-rate interface:
Specify a Controller: To configure the available channelized full-rate bandwidth of an interface on port
Step 1
1 of a line card in router chassis slot 2, you must first select the E1 controller from the global
configuration mode:
Router(config)# controller e1 2/0/1
Router(config-controller)
Specify a Channel Group: To specify a channel group number for a full-rate channelized E1 port, you
Step 2
assign a channel-group number from 1 to 31 from the controller configuration mode:
Router(config-controller)# channel-group 7 timeslots 1-31
Router(config-controller)
This command assigns channel-group number 7 and timeslots 1 through 31 (the maximum available
1984 kbps channelized E1 bandwidth) to port 1 of the line card in router chassis slot 2.
Specify Controller Parameters: to specify any other controller parameters you enter the controller
Step 3
parameters for the port you have selected (see
Commands" section on page
Specify Interface Parameters: Go to interface configuration mode for any channel group you created
Step 4
and specify interface parameters:
Configuring Fractional Channelized E1 Bandwidths
To configure an available channelized (framed) fractional E1 bandwidth on a port, you must select the
E1 controller from the global configuration mode.
The following two examples in this step show you how to configure all the available port 2 E1 timeslots
Step 1
into two interfaces:
Example 1:
Router(config)# controller e1 2/0/2
Router(config-controller)# channel-group 8 timeslots 1, 2, 5, 11-31
Router(config-controller)#
These commands configure port 2 time slots 1, 2, 5, and 11 to 31, of the line card in router chassis slot
2 as channel-group (interface) number 8.
Cisco 10000 Series Router Line Card Configuaration Guide
5-8
5-17).
Router(config)# interface serial 2/0/2:6
Router(config-if)#
Chapter 5 24-Port Channelized E1/T1 Line Card Configuration
Table 5-2 on page 5-2 and the "Controller Configuration
OL-8834-04