Removing A Flash Memory Card; Power Management And Environmental Monitoring; Determining Software Feature Support; Configuring A Supervisor Engine Or Route Switch Processor - Cisco 7600 Series Manual
Router supervisor engine and route switch
Hide thumbs
Also See for 7600 Series:
- Hardware installation manual (144 pages) ,
- Module manual (128 pages) ,
- Hardware manual (122 pages)
Table of Contents
Advertisement
Power Management and Environmental Monitoring
Removing a Flash Memory Card
Do not remove a flash memory card while its LED light is on or the file may become corrupted.
Caution
To remove a flash memory card, follow these steps:
Make sure that the Disk LED is off (no operations are in progress).
Step 1
Press the ejector button to disconnect the memory card from the connector at the back of the slot.
Step 2
Remove the memory card from the slot and place it in an antistatic bag.
Step 3
Power Management and Environmental Monitoring
For detailed information on power management and environmental monitoring, see the Cisco 7600
Series Router Cisco IOS Software Configuration Guide.
Determining Software Feature Support
This section describes the Feature Navigator and Software Advisor tools. You can use these tools to
determine which features are supported on the router and the minimum Cisco IOS software requirements
for the hardware installed on your router.
You must have an account on Cisco.com to access the Feature Navigator or Software Advisor tool.
Note
•
•
Configuring a Supervisor Engine or Route Switch Processor
See the Cisco 7600 Series Router Cisco IOS Software Configuration Guide for information about how
to configure the supervisor engine or route switch processor for operation.
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
3-14
To determine which software features are supported by your route switch processor or supervisor
engine, use the Feature Navigator tool at the following URL:
http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp
To check the minimum Cisco IOS software requirements for the hardware installed on your router,
use the Software Advisor tool at the following URL:
http://www.cisco.com/public/support/tac/tools.shtml
This tool does not verify whether the line cards in a system are compatible, but it does provide the
minimum Cisco IOS requirements for individual line cards, modules, or options.
Chapter 3
Installing and Configuring Route Switch Processors and Supervisor Engines
OL-10100-04
Advertisement
Table of Contents
