Subaru legacy 2017 Owner's Manual page 230

To Operate the Auto-Dimming Fea-
ture
Press the switch to turn the auto-
dimming feature on/off. The auto-dimming
feature is enabled when the switch s
green LED indicator is on. The auto-
dimming feature will default to on with
each ignition cycle.
To Operate the Compass Feature
1. To turn the compass feature on/off,
press and hold the switch for more
than 3 seconds or until the display turns
on/off. The compass feature will default to
on with each ignition cycle.
2. If the display reads C , slowly drive
the vehicle in circles until compass is
calibrated.
Compass calibration zones
3. To adjust for compass zone variance:
(1) Find your current location and
zone number on the map.
(2) Press and hold the
more than 6 seconds or until a zone
number appears in the display.
(3) Once the zone number appears in
the display, toggle the
again until your current location zone
number appears. After you stop press-
ing the switch, your new zone number
will be saved. Within a few seconds,
the display will show a compass
direction.
4. If the vehicle s magnetics have chan-
ged or if the compass appears inaccurate,
recalibrate the compass. Press and hold
the switch for more than 9 seconds or
until a C appears in the display. Once a
C appears in the display, slowly drive the
vehicle in circles until compass is cali-
brated.
HomeLink Wireless Control Sys-
®
tem
The HomeLink Wireless Control System
®
provides a convenient way to replace up
to three hand-held radiofrequency re-
motes used to activate devices such as
gate operators, garage door openers,
entry door locks, security systems, even
home lighting. The below steps are
Instruments and controls/Mirrors
generic programming instructions; for
Genie and Sommer garage door openers
please go directly to the HomeLink
website. Additional information and pro-
switch for
gramming videos can be found at
www.HomeLink.com and
www.youtube.com/HomeLinkGentex.
switch
. Before programming HomeLink
to a garage door opener or gate
operator, make sure that people
and objects are out of the way of
the device to prevent potential
harm or damage.
. When programming a garage
door opener, it is advised to park
outside of the garage.
. Do not use HomeLink
garage door opener that lacks
safety stop and reverse features
as required by U.S. federal safety
standards (this includes any gar-
age door opener model manufac-
tured before April 1, 1982). A
garage door that cannot detect
an object signaling the door to
stop and reverse does not meet
current U.S. federal safety stan-
dards.
. It is also recommended that a
3-75
®
CAUTION
®
with any
®
CONTINUED