Subaru legacy 2017 Owner's Manual page 199

3-44
Instruments and controls/Multi information display
Screen Settings
After entering the Screen Settings menu,
select one of the following menus.
Welcome Screen
The welcome screen can be activated or
deactivated. Select On (with Sound) to
activate the screen and sound. Select On
(without Sound) to activate the screen
and deactivate the sound. Select Off to
deactivate the screen.
Good-bye Screen
The Good-bye screen can be activated or
deactivated. Select On to activate the
screen. Select Off to deactivate the
screen.
Gauge Initial Movement
The movement of the meter needles and
gauge needles that occurs when the
ignition switch is turned to the ON
position can be activated or deactivated.
Select On to activate. Select Off to
deactivate.
Gear Position Indicator Settings
(MT models)
The gear position indicator light can be
activated or deactivated. Select On to
activate. Select Off to deactivate.
Units
You can select the displayed units of the
distance, vehicle speed and volume.
Operate the or switch on the
steering wheel to display the preferred
units. Then pull the /SET switch to
select the displayed units.
Languages
Operate the or switch on the
steering wheel to display the preferred
language. Then pull the /SET switch to
select the displayed language.
Combination Meter Illumination (if
equipped)
After entering the Combination Meter
Illumination menu, select the following
menu.
Meter Ring Illumination
The illumination of the combination meter
rings can be activated or deactivated.
Select On to activate the illumination.
Select Off to deactivate the illumination.
EyeSight (models with EyeSight
system)
NOTE
For models with the EyeSight system,
refer to the Owner s Manual supple-
ment for the EyeSight system.
After entering the EyeSight menu, select
one of the following menus.
Warning Volume
The volume of the warning buzzer that
sounds when the EyeSight system is in
use can be set in 3 stages ( Max , Mid
and Min ).
Lead Vehicle Acquisition Sound
When adaptive cruise control is used, the
buzzer that sounds under any of the
following conditions can be activated or
deactivated.
. A vehicle is detected in front
. Detection is not possible
Select On to activate the buzzer. Select
Off to deactivate the buzzer.
Lead Vehicle Moving Monitor
Function
When the lead vehicle moving monitor
function is operated, the buzzer that
sounds if a vehicle in front has started
can be activated or deactivated. Select
On to activate the buzzer. Select Off to
deactivate the buzzer.
Vehicle Icon
The vehicle icon indication can be acti-
vated or deactivated. Select
activate. Select Off to deactivate.
On to