Subaru legacy 2017 Owner's Manual page 207

3-52
Instruments and controls/Light control switch
Press and hold the automatic
dimming on/off button for 15 to 20
seconds again.
How to change the headlight
mode manually
Change to the low beam:
When you return the turn signal lever to
the center position, the high beam assist
function will turn off and the high beam
assist indicator will turn off.
Change to the high beam:
When you turn the light control switch to
the position, the headlight mode will
be changed to the high beam.
At this time, the high beam assist function
will turn off, the high beam assist indicator
will turn off and the high beam indicator
light will turn on.
NOTE
. After manually changing the head-
light mode to the high beam, if you turn
on the high beam assist function,
return the light control switch to the
AUTO position.
. When manually changing the head-
light mode to the high beam, if you turn
the light control switch to the
position, the parking lights, front side
marker lights, rear side marker lights,
tail lights and license plate lights will
turn on.
Tips for the high beam assist
system
. The high beam assist function recog-
nizes the condition surrounding the vehi-
cle based on the brightness of illumination
ahead of your vehicle, etc. Therefore, the
headlight mode may switch in some
situations that do not match to the driver s
sense.
. A bicycle or cargo cycle may not be
detected.
. Under the following situations, the
brightness of ambient illumination may
not be detected correctly and the high
beam assist function may not work prop-
erly. As a result, the glare of the high beam
may disturb the driving of an oncoming
vehicle or vehicle ahead. Also, the low
beam mode may continue although there
are no oncoming vehicles and vehicles
ahead. In the such cases, change the
headlight mode manually.
In bad weather (fog, snow, sand
storm, heavy rain, etc.)
When the windshield glass is dirty
or fogged
When the windshield is cracked or
damaged
When the inside mirror or the
camera is deformed or dirty
If there are lights similar to the
headlights or the tail lights in the
surrounding area
When an oncoming vehicle or ve-
hicle ahead is driven without its head-
lights and tail lights on
If the headlights of an oncoming
vehicle or the tail lights of a vehicle
ahead are dirty or discolored, or if the
light beams are not aimed correctly
When a rapid change of brightness
continues while driving
When driving on a road with many
ups and downs or uneven surfaces
When driving on a road with many
curves
When there are some objects that
reflect light strongly, such as a road
sign or a mirror in vehicle ahead
When the rear part of the vehicle
ahead, such as a container, reflects
light strongly
When the headlights of your vehicle
are damaged or dirty
When your vehicle is tilted, such as
in case the vehicle has a flat tire or is
being towed
. In the following conditions, the head-
light mode will not be automatically chan-
ged from the high beam to the low beam.
When your vehicle passes an on-
coming vehicle suddenly in a blind