Pin Code Access (Models With Keyless Access With Push-Button Start System ); Registering A Pin Code - Subaru legacy 2017 Owner's Manual

2-22
Keys and doors/PIN Code Access (models with keyless access with push button start system )
PIN Code Access (models
with keyless access with
push-button start system )
1) Trunk opener button (Legacy)
1) Rear lock button (Outback)
While all doors (for Outback, including the
rear gate) are locked, you can unlock the
doors (including rear gate) without a key
by performing the following procedure.
. Legacy: press the trunk opener button
. Outback: press the rear lock button
NOTE
PIN Code Access will be helpful if the
key is accidentally left in the vehicle. It
is recommended that a 5-digit security
code (PIN code) is registered.

Registering a PIN code

Preparation
1. Turn off the ignition switch.
2. Close all doors (including trunk/rear
gate).
3. Press and hold the button on the
access key. Then all doors (including rear
gate) will be locked.
4. Keep the button pressed, and
press the following button within 5 sec-
onds after step 3.
. Legacy: the trunk opener button
. Outback: the rear lock button
5. Press and hold the above button for
more than 5 seconds. Then a chirp will
sound.
6. Press the button on the access key
while the chirp sounds.
Then the chirp will stop and the prepara-
tion is complete.
NOTE
If you do not press the
the access key, the chirp will sound for
30 seconds. In this case, the prepara-
tion for registering a PIN code does not
complete even if the chirp stops.
button on