Honda Accord 4D 2003-2006 Owner's Manual page 53

03/09/03 14:11:47 32SEA610_053
Protecting Children
Using a Seat Belt Locking Clip
(Except EU models)
On cars without additional locking
mechanism fitted to the seat where the
child is positioned
Always use a seat belt locking clip
when you secure a child restraint
system to your car's front passenger's
seat with a lap/shoulder belt. This
helps prevent the restraint system
from shifting position or overturning.
A locking clip is usually included
with the child restraint system. If
you need a clip, contact the seat's
manufacturer or a store that sells
child restraints.
If it is necessary to put a front facing
child restraint system in the front,
move the vehicle seat as far to the
rear as possible, be sure the child
restraint system is firmly secured to
the car, and the child is properly
strapped in the restraint system (see
page 45 ).
50
Driver and Passenger Safety
To install a locking clip, do the
following:
1. Place the child restraint in the
front passenger's seat. Route the
lap/shoulder belt through the
restraint according to the seat
manufacturer's instructions.
2. Insert the latch plate into the
buckle. Pull on the shoulder part
of the belt to make sure there is
no slack in the lap portion.
3. Tightly grasp the belt near the
latch plate. Pinch both parts of the
belt together so they won't slip
through the latch plate. Unbuckle
the seat belt.
LOCKING CLIP
Install the locking clip as shown.
4.
Position the clip as close as
possible to the latch plate.