Honda Accord 4D 2003-2006 Owner's Manual page 371

03/09/10 18:13:06 32SEA610_371
Engine Oil (Diesel models)
OIL FILTER
Remove the oil filter and let the
4.
remaining oil drain. A special
wrench is required to remove the
filter.
When removing the oil filter, put a
damp rag over any other
compartment near the filter, so that
oil doesn't spill.
If you are not sure how to replace
the oil filter, contact your Honda
dealer.
368
Maintenance
5. Install a new oil filter according to
instructions that come with it.
6. Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten it to:
39 N·m (4.0 kgf·m , 29 lbf·ft)
7. Refill the engine with the recom-
mended oil.
Engine oil change capacity
(including filter):
5.9 (6.2 US qt , 5.2 Imp qt)
8. Replace the engine oil fill cap.
Start the engine. The oil pressure
indicator should go out within five
seconds. If it does not, turn off the
engine and check your work.
9. Let the engine run for several
minutes, then check the drain bolt
and oil filter for leaks.
10. Turn off the engine, let it sit for
several minutes, then check the oil
level. If necessary, add oil to bring
the level to the upper mark on the
dipstick.
11. Install the maintenance lid and
tighten the bolt securely.
Improper disposal of engine oil can
be harmful to the environment. If
you change your own oil, please
dispose of the used oil properly. Put
it in a sealed container and take it to
a recycling centre. Do not discard it
in a waste bin or dump it on the
ground.