Honda Accord 4D 2003-2006 Owner's Manual page 234

03/09/03 14:38:45 32SEA610_234
You can use any of five methods to
find radio stations on the selected
band: TUNE, SEEK, SCAN, AUTO
SELECT, and the preset bars.
TUNE Use the TUNE bar to tune
−
the radio to a desired frequency.
Push the on the TUNE bar to
tune to a higher frequency, or push
the to tune to a lower frequency.
Hold the bar down until the display
reaches the desired frequency.
SEEK − The SEEK function
searches the band for a station with
a strong signal. To activate it, press
the SEEK bar ( or
you hear a beep, then release it.
Depending on which side of the
SEEK bar you press, the system
scans upward or downward from the
current frequency. It stops when it
finds a station with a strong signal.
The SCAN function
SCAN −
samples all the stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan up
the band for a station with a strong
signal. When it finds one, it will stop
and play that station for
approximately five seconds. If you do
nothing, the system will then scan
for the next strong station and play
that for five seconds. When it plays a
station that you want to continue
listening to, press the SCAN button
again.
) until
Audio System (C, D Type)
You can store the
Preset −
frequencies of your favorite radio
stations in the three preset bars.
Each bar will store two frequencies
on each AM band (LW, MW), and
four frequencies on the FM band.
To store a frequency:
1. Select the desired band, AM (LW),
AM(MW) or FM. FM1 and FM2
let you store two frequencies with
each preset bar.
2. Use the TUNE, SEEK, or SCAN
function to tune the radio to a
desired station.
3. Pick the preset number (1
you want for that station. Press
the left or right side of the bar and
hold it until you hear a beep.
4. Repeat steps 1 to 3 to store a total
of six stations on each AM (LW,
MW) and twelve on FM.
CONTINUED
Comfort and Convenience Features
− 6)
231