Table of Contents
Advertisement
Installing a Computer
To connect a computer
1. Slide the computer into place on the bottom storage shelf, above the computer straps, and then
secure the straps around the computer.
NOTE: The straps allow you to roll the unit from room to room without removing the computer.
However, these straps will not secure the computer in place during unit shipment. If you ship the
unit, remove the computer first.
2. Locate the bundle of labeled cables (to the right of the projector) hanging down towards the
storage tray.
3. Connect the Computer 1 Video cable to the Monitor Video connector.
4. Connect the Computer 1 Audio cable to the Audio Line OUT connector.
5. Connect the Computer 1 Serial cable to an available COM port.
NOTE: To connect a computer that has no available serial port, connect the SMART USB
adapter (supplied in the accessory kit) between the Computer 1 Serial cable and the USB port
on the computer.
6. Connect the Mouse and Keyboard cables (not supplied) to the PS/2 mouse port and the PS/2
keyboard port on the computer.
To connect the power cables
1. Connect the Computer AC power cable to an available power outlet or power bar (not supplied).
2. Connect the 2000i AC
connect this AC cord to an available power outlet or power bar (not supplied).
10
Computer 1 Serial (Female)
Computer and Power Cables
power cord to the country-specific AC cord in the accessory box. Then
2000i-DVX Installation Guide
Computer 1 Audio
Computer 1 Video (Male)
2000i AC (Male)
(Connect to female country-specific AC cable)
Advertisement
Table of Contents
