Table of Contents
Advertisement
The Display Properties dialog box appears.
3. Click the Settings tab.
4. Move the slider to 1024 x 768.
5. Click the Apply button and then click OK.
6. Restart your computer, if required.
To set your Macintosh computer resolution to match the projector resolution
1. Click the Apple menu.
2. Click Control Panels.
3. Select Monitors.
The Monitors dialog box appears.
4. Click the Options button.
5. In the Select a monitor setting list, select 1024 x 768, and then click OK.
Installing SMART Board Software
The installation process should start automatically after you insert the SMART Board software CD
into your CD-ROM drive. Otherwise, install the software as follows.
To install SMART Board software for Windows operating systems
1. Insert the SMART Board software CD into your CD-ROM drive.
The SMART Board software setup program should start automatically. If it doesn't, select Start >
Run and enter x:\autorun.exe (where x: is your CD-ROM drive). Follow the on-screen
instructions to install SMART Board software.
At the end of the installation, you can choose to put a shortcut to SMART Board software in your
Startup Folder. We recommend that you do so. Then the SMART Board tools will always be
open, and your interactive whiteboard will be fully functional when you start up your system.
2. Click Yes to insert a shortcut to SMART Board software in the Startup folder, or click No to
prevent SMART Board software from starting whenever you start up your system.
To install SMART Board software for Macintosh computers
1. Insert the SMART Board software CD into your CD-ROM drive.
2. Double-click the SMART Installer icon.
The SMART Installer window appears.
3. Click the Continue button and then follow the instructions on your screen.
Configuring and Orienting the Interactive Whiteboard
After you install SMART Board software, you must configure and orient the interactive whiteboard.
You may need to specify whether the serial or USB port on the host computer connects to the
interactive whiteboard. If you're running SMART Board driver version 6.0 (or later), the COM port
configuration process is entirely automatic, unless:
•
the Windows operating system you're running does not perform plug and play (e.g., Windows NT
4.0 or ME)
22
2000i-DVX Installation Guide
Advertisement
Table of Contents
