Table of Contents
Advertisement
IMPORTANT: Keep your finger straight as it approaches the screen. Press it firmly on each
cross, and keep it straight as you pull it away from the screen.
8. Test the orientation by dragging your finger across the screen. The cursor should track your
finger very closely and appear directly beneath the center of your fingertip.
Calibrating the Cameras (DViT Technology)
With DViT technology, small cameras that are located in the corners of the interactive whiteboard
frame detect contact with the screen. For the screen to function properly, these cameras must be
precisely calibrated so the computer can provide an accurate and appropriate response to screen
contact.
You should recalibrate the cameras (and re-orient the screen) if areas of the screen have inaccurate,
erratic or absent touch sensitivity, or if the electronic ink that appears when you write on the screen is
jagged, broken or even absent.
To recalibrate the cameras
1. Press the SMART Board icon in the system tray, and select Control Panel.
The SMART Board Control Panel opens.
2. On the Boards tab, press the Advanced button.
The Edit Advanced Board Settings dialog box opens.
3. Press the DViT Settings tab.
4. Press the Calibrate button.
The four-point calibration screen appears.
5. Press and hold your finger on the center of each target until the target moves.
After you press the final target, a message appears, followed immediately by the orientation
screen.
6. Complete the orientation procedure.
7. Press OK.
Connecting a Guest Laptop
You can connect and control a laptop presentation by touching the screen only if you:
•
purchase and install the X-Port 20 switch option for the 2000i
•
install SMART Board software on the laptop
The X-Port 20 unit is an RS-232 serial switch for establishing a serial connection with the laptop,
enabling the laptop user to both write over top of the displayed laptop image with a pen tray stylus
and control the contents of the laptop by touching the interactive screen. In addition, it allows you to
switch between the laptop, the resident computer and a VCR/DVD player using the Control Panel at
the front of the 2000i. If a guest laptop requires a USB connection to the 2000i, purchase the optional
USB-ADP cable from SMART Technologies to convert USB to serial.
Complete instructions for installing the X-Port 20 switch and connecting a guest laptop are in the
X-Port 20 Switch Installation Guide that comes with the X-Port 20 option kit.
Connecting a VCR or DVD Player
24
2000i-DVX Installation Guide
Advertisement
Table of Contents
