Error Messages Output By The Gui Tool, And Vss Provider; E1000007; E1000008; E100000D - HP XP User Manual

Error messages output by the GUI tool, and VSS Provider

NOTE: Disregard any message ID (Exxxxxxx) that is not listed in table 8.3.3-1 and proceed
with the next message ID In the log.

E1000007

Message
Configuration file does not have any IP addresses or Serial Numbers.
Explanation
The proper IP address format is not used in the setup file.
Recommended action
Confirm the IP address of the disk array system using Storage Management Software, and
set the IP address or serial number of the disk array system using the proper format in the
setup file (see Subsection 3.2.1).
Confirm that single-byte alphanumeric characters are used in the setup file.

E1000008

Message
Configuration file not found: [filename]
Explanation
The setup file is not found.
Recommended action
Confirm that the setup file is stored in the installation folder of VSS Provider. If the setup file does
not exist, create the setup file, and save it in the installation folder (See Subsection 3.2.1).

E100000D

Message
Invalid IP:[IP address] in configuration file.
Explanation
The value of the IP address specified to the setup file is invalid.
Recommended action
Confirm the IP address of the disk array system using Storage Management Software, and set
the IP address of a proper disk array system in the setup file (See Subsection 3.2.1).

E100000F

Message
Failed to create storage API object for IP:[IP address]
Explanation
Communication with a disk array system is impossible.
Recommended action
An error occurred when an operation command was given to a disk array system.
82 Troubleshooting