E20020E5 - HP XP User Manual

8.5. If the resource has been used by another user, Storage Management Software and so
on, this message can be ignored.
(2) An error occurred when a resource was locked using RAID Manager. See message ID:
solution for E1000149.
(3) An error occurred when an operation command was given to the disk array system.
See "About errors attributable to disk array systems" (page

E20020E5

Message
Split S-Vol [LU# of S-Vol] failed. Please retry the operation.
Explanation
Failed to split the S-VOL pair.
Recommended action
(1) Retry the pair split processing of S-VOL after refreshing or rebooting the GUI tool.
(2) Confirm that the Business Copy pair to be split exists in the disk array system using
Storage Management Software.
(3)Restart the GUI tool in only the case that the Account Authentication function enabled
disk array system is registered.
(4) Confirm that this operation does not infringe on the Operational restrictions and points
of consideration when using HPE RAID Manager. See Table2.5.2-3.
(5)Pair status of the specified S-VOL is not ready for the pair split. Check the pair split status.
(6)An error occurred when a pair operation command was given to the disk array system.
See "About errors attributable to disk array systems" (page
E20020E6
Message
IP Addresses, User Name or Password is incorrect.
Explanation
IP address, user name or password of vCenter Server is not correct.
Recommended action
(1) Confirm that account of the specified user name is the administrator privileged account.
(2) Confirm that the specified IP address is for vCenter Server. Check that the specified user
name and password are the user name and password for the vCenter Server Windows logon
account. To specify the domain user name, specifying domain name is not required. Example:
For Domain name\User name, specify the user name only.
(3)Confirm that the corresponding virtual machine is the one on ESXi server managed by
vCenter Server specified with the IP address.
(4)See Subsection 2.3.5 to confirm the required software settings to use the VMware Guest
to Guest Backup (FC) function.
(5)Confirm that no problem with the connection between vCenter Server and ESXi as well
as between ESXi and disk array system. See Subsection 8.4.2.
(6)If the VMware Guest to Guest Backup (FC) function is not used, ignore this error.
133).
133).
Error messages 129