Brother FAX-2840 Service Manual page 274

APPENDIX 3 INSTALLING MAINTENANCE DRIVER
To identify multiple machines connected to the computer via USB, the computer needs to
configure the corresponding number of virtual USB devices by a driver or software. If you
connect a multiple number of machines to your computer, the same number of virtual USB
devices will be automatically configured on your computer.
To prevent virtual USB devices from being configured without limitation, use the unique
driver installation procedure described below that enables your computer to identify
multiple machines via one single virtual USB device.
<Procedures>
(1) While the machine is in the ready state, press the [OK] button and then the [Start]
button. Next, press the [
(2) " MAINTENANCE
maintenance mode.
(3) Double-click "Setup.exe" for the maintenance printer driver stored in the temporary
folder to execute it.
(4) The Device Driver Installation Wizard startup window appears. Click [Next].
(5) The alert window appears three times. Click [Continue Anyway] on each window to
continue installation.
(6) The Device Driver Installation Wizard completion window appears. Click [Finish].
(7) Connect the machine to your computer using the USB cable.
(8) The Found New Hardware Wizard startup window appears. Select "No, not this time"
and click [Next].
(9) Select "Install the software automatically (Recommended)" and click [Next].
(10) The alert window appears. Click [Continue Anyway].
(11) When the driver is installed successfully, the Found New Hardware Wizard completion
window appears. Click [Finish].
Repeat steps from (9) to (11) three times to complete the driver installation procedure.
(12) Disconnect the USB cable.
(13) Press the [
the [OK] button. The machine exits the maintenance mode and returns to the ready
state.
] button four times to enter the maintenance mode.
" appears on the LCD, and the machine goes into the
] or [ ] button to display "MAINTENANCE 99" on the LCD. Then, press
App. 3-1 Confidential