Parts Life Reset Function (Drum); Deletion Of User Setting Information, Etc - Brother FAX-2840 Service Manual

2.2

Parts Life Reset Function (Drum)

This function is used to reset the relevant part counter when the user replaced a periodical
replacement part with the correct procedure, and also used to forcibly reset the relevant part
counter when an error cannot be reset because the user did not replace a consumable part
with the correct procedure.
(1) Press the [3] and [9] buttons at the same time while the machine is in the ready state.
(2) "Reset Menu Drum" appears on the LCD. Press the [OK] button.
(3) "Drum 1.Reset 2.Exit" appears on the LCD. Press the [1] or [2] button.
(4) When the [1] button is pressed, the counter is cleared.
Note:
• All replacement parts are always displayed on the LCD even though they have not yet
reached the end of life.
• The machine returns to the ready state automatically if no panel operation is performed for
30 seconds.
2.3

Deletion of User Setting Information, etc.

In this machine, the user setting information is stored in the EEPROM and flash memory of
the main PCB. You can delete all the data listed below at a time with the procedure given
below.
• Information related to Net
• User setting information
<Operating Procedure>
(1) Press the [Menu] button while the machine is in the ready state.
(2) Press the [
button.
(3) Press the [
(4) Press the [
button.
(5) "1.Reset 2.Exit" appears on the LCD.
(6) Press the [1] button, and "Reboot OK? 1.Yes 2.No" appears on the LCD.
(7) Press the [1] button, and "Accepted" appears on the LCD. The user setting information is
deleted, and the machine returns to the ready state.
Note:
• The machine returns to the ready state automatically if no panel operation is performed for
30 seconds.
] or [ ] button to display "Initial Setup" on the LCD, and press the [OK]
] or [ ] button to display "Reset" on the LCD, and press the [OK] button.
] or [ ] button to display "All Settings" on the LCD, and press the [OK]
5-41
Confidential