Removing The G430 Cover - Avaya G450 Configuration Manual

Installing the MP120 VOIP module

Removing the G430 cover

About this task
Voltage:
Disconnect the G430 from the external power source before proceeding.
Electrostatic alert:
Do not touch any components on the printed circuit board.
Procedure
1. Disconnect the G430 power cable from the mains power supply.
2. Note to which connector each cable is connected, so that you can reconnect them
3. Disconnect all cables (data and power) connected to the G430 and the media
4. Remove the G430 from the rack or wall, if it is wall or rack mounted.
5. If mounting brackets are attached to the G430, remove them.
6. Unscrew the 8 cover screws, indicated by small arrows etched into the cover:
7. Lift the cover off the G430.
22 Configuring V.150.1 on Avaya G450 and G430 Branch Gateway
correctly.
modules, both front and rear.
• Remove one screw from the top (see
• Remove four screws from the right side (see
• Remove three screws from the left side (see
Figure 5: Removing the G430 cover screw from the top of the device
Comments? infodev@avaya.com
the figure on page 22).
the figure on page 23).
the figure on page 23).
May 2014