Avaya G450 Configuration Manual page 16

Installing the MP160 VOIP module
Electrostatic alert:
Hold modules only by the edges to avoid damage from static electricity. Do not touch the
top or bottom of the circuit board. If possible, wear a wrist-strap and use an anti-static
bag.
Caution:
The connector pins can get bent or damaged if you handle the module roughly or if you
misalign the module before forcing the module into position.
Caution:
Attach the correct standoff according to the hardware version of the G450. Using the wrong
standoff will prevent you from installing the MP160 correctly.
About this task
You do not need to configure the G450 when you install an MP160. However, you must
configure V.150.1 in Communication Manager in order to support V.150.1 applications such
as modem-over-ip. See
Procedure
1. Insert the provided plastic standoff in the hole.
16 Configuring V.150.1 on Avaya G450 and G430 Branch Gateway
Configuring V.150.1
The standoff type differs depending on the hardware version of the G450. Ensure
you use the correct standoff.
Figure 1: Location of Standoff on MP160
Comments? infodev@avaya.com
on page 29.
May 2014