Ip Codec Set - Avaya G450 Configuration Manual

Configuring V.150.1 in Communication Manager
10. In the FAX field, type .
11. In the Modem field , type v150mr.
12. Access Page 3.

IP codec set

Use this screen to specify the type of codec used for voice encoding and companding
(compression/decompression).
The default codec is set for G711. The G711 provides the highest voice quality, but G711 uses
the maximum bandwidth. If G711 does not meet the required voice-quality or bandwidth trade-
off specification, you can change the G711 default setting.
To modify the values of the fields on this screen, use the following command:
change ip-codec-set n, where n is the IP codec set number.
30 Configuring V.150.1 on Avaya G450 and G430 Branch Gateway
FAX
Modem
TDD/TTY
Clear Channel
You must enter v150mr in the Modem field (on page 2 of the ip-codec-set form)
before you can access Page 3.
For example:
change ip-codec-set 1
Note: Maximum SPRT Payload sizes may vary across different gateways
dependent on firmware/hardware version
SPRT Payload Sizes (bytes)
SPRT Window Sizes (packets)
SPRT Timer TA01 (msec)
SPRT Timer TA02 (msec)
SPRT Timer TR03 (msec)
SPRT Retransmissions: 3
SSE Repetition Redundancy (packets): 3
SSE Inter-Packet Interval (ms): 20
Modem Relay Preferred (NoAudio)? N
Modulation Mode
V.32? y V.34? y
Comments? infodev@avaya.com
Mode
off
v150mr
US
n
V.150 MODEM RELAY PARAMETERS
TC0 TC1
140 132
- 32
- 90
- 130
- 500
V.90? n V.92? n
Allow Direct-IP Multimedia? n
Redundancy
0
0
3
0
Page
TC2 TC3
132 140
8 -
90 -
500 -
500 -
V.42 Error Correction? n
3 of 3
May 2014