To Check The Motherboard, Cpu, And Ram - Agilent Technologies 54835A Service Manual

To check the motherboard, CPU, and RAM

This procedure verifies that the PC system board and the associated CPU and RAM are
functioning. It assumes that the power supply, SVGA display board, and an external VGA monitor
are functioning correctly.
Connect an external keyboard to the keyboard port.
1
Connect an external VGA monitor to the VGA output connector on the rear panel.
2
Hold down the Insert key on the external keyboard, then apply power to the
3
oscilloscope.
Verify that a message, such as the following, appears on the external monitor:
4
AMI Atlas-III PCI/ISA
AMD-K6(tm)-/200
Checking NVRAM
16000 KB OK
WAIT...
<INS> Pressed
RUN SETUP
Press F1 to Resume
Messages Vary Slightly
These messages may vary slightly depending on the motherboard version.
If the above message is displayed, you can assume that the PC system board, CPU, and RAM are
functioning correctly.
If the message is not displayed or there is no display, remove the GPIB interface board and LAN
interface board and try the test again. Procedures to remove the interface boards are given in
chapter 6, "Replacing Assemblies."
If you need to run setup, press F1. Otherwise, turn off power and proceed with troubleshooting.
See "To configure the motherboard jumpers and set up the BIOS" for information.
Chapter 5: Troubleshooting

To check the motherboard, CPU, and RAM

5–21